S22+/S30 self-order terminal installation instructions for wall mounting

S22+/S30 self-order terminal installation instructions for wall mounting

What
Installation instructions for wall mounting for the S22+/S30 self-order terminal.


Preparations

a. Extension screws M8*60mm 4pcs

(Note: After testing, it has been determined that for S22+/S30 kiosk units, the use of M8*60mm expansion screws are essential for wall mounting. The use of screws below this standard can lead to risks for the load-bearing capacity. For safety reasons, you should not compromise on screw standards).




b. Hand screws M4*8mm 4pcs.




c. Wall bracket 1 pc.




d. Kiosk (with 4 small hooks, hooks as shown in the following picture)




Procedure

1. Drill 4 holes with a diameter of 10 mm and a depth of 45 mm in the wall as shown in the illustration:

 


2. Remove the 4 expansion screws as shown below:




3. Mount the 4 expansion screws with the wall bracket and make sure that you do not tighten them at first. Then insert them into the 10*45mm pre-drilled holes on the wall and finally fasten both the expansion screws and the wall bracket.




4. Mount the kiosk with the wall bracket and fasten the kiosk with hand screws.